Angular Contact Ball Bearings

Angular Contact Bearings

Angular contact ball bearings are classified as single row, radial ball bearings. However, many refer to them incorrectly as thrust bearings because they are designed to carry a heavier axial load. Unlike other radial ball bearings, the contact points through the angular contact bearing are measured in terms of how far they deviate from the normal pure radial load (at a 90° angle to the shaft). Angular contact bearings are designed to operate with an internal contact angle of either 15°, 30° or 40° from the standard 90° angle to the shaft. NTN’s designations for the various contact angles are as follows:

NTN Designation for Angular Contact Bearings

These bearings are designed for the balls to ride high on the edge of one of the raceways: the raceway on the opposite side of the outer ring is much shorter to accommodate assembly. If the angular contact bearing is installed facing the wrong direction, it will separate and result in a catastrophic premature bearing failure.

NTN’s designation for this type of bearing is a 7 in the first position of a four (4) digit base bearing number.

Examples of the NTN Angular Contact Bearing Series

Before (A=B) After Flush Ground

After an angular contact bearing is installed, excessive end play, or the axial movement of one ring in relationship to the other before subjected to any external load, may lead to premature bearing failure. The illustration to the right (labeled "Before") shows the shift that occurs (Offset A and B), which is referred to as stickout. To control end play, the faces of the bearings are flush ground as pictured in the illustration also to the left (labeled "After"). They may now be duplexed (see below). Maintaining this controlled end play promotes good load sharing support by each bearing, eliminating heat generation and power loss. NTN designates that a bearing is flush ground with the suffix G.

See Also:

Duplexing of Angular Contact Bearings